U-blox Driver Download For Windows 10
U-blox M8 UDR module including 3D inertial sensors. The NEO-M8U module introduces u‑blox’s Untethered Dead Reckoning technology, which provides continuous navigation without requiring speed information from the vehicle.
- U-Blox USB Sensor/VCP Driver 2.1.0.8 145 downloads. Other Drivers & Tools Other. Huawei GNSS Sensor Driver 1.1.25.0 for Windows 10 109 downloads. Other Drivers & Tools Other. Jan 15th 2016, 11:23 GMT. U-Blox USB Sensor CDC-ACM Driver 1.2.0.8.
- In this very quick tip I share how you get hold of the GNSS configuration software. You can download it from this page - https://www.u-blox.com/en/product-re.
- Click Download File to download the file. When the File Download window is displayed, click Save to save the file to your hard drive. Browse to the location where you downloaded the file and double-click the new file. Read the information in the dialog window.
Installing the u-blox USB drivers for Windows for use with RTKLIB can be a little tricky now that u-blox has switched their default Windows configuration from using COM port drivers to using sensor device drivers. RTKLIB does not support sensor device drivers, so it is necessary to force the driver installation process to revert to a driver that supports the COM port interface.
To make things more confusing, there are actually three different drivers that will support the COM port interface. You can determine which driver you are using by opening the Windows Device Manager while the u-blox reciever is plugged into the computer. The receiver will either show up under “Ports” or under “Sensors”. If it shows up under “Sensors” then RTKLIB will not be able to see it. Here is an example of what it looks like when it shows up under “Ports”:
If it shows up under “Ports” it may be listed in one of three different ways depending on which driver is installed. They are:
USB Serial Device (COMx): This is the generic COM port Windows driver and is what u-blox recommends for Windows 10 when using the COM port interface. It will work fine with RTKLIB, but Windows has an annoying habit of automatically replacing it with the sensor driver, so I have recently stopped using this one.
u-blox Virtual COM Port (COMx): This is the driver recommended by u-blox if you want to support both the sensor interface and the COM port interface. It has some limitations though, the primary one being that you can only run one of these devices on a computer at a time, so I don’t recommend this one either.
U-blox Software
u-blox GNSS Reciever (COMx): This is the older u-blox driver before they switched to the sensor interface. U-blox recommends this for older versions of Windows but I have started using this recently with Windows 10. So far I have found it works fine, and it does not automatically get replaced by Windows like the generic driver does. I recommend this one.
All three u-blox drivers are available for download from their Product Resources page. The older driver is listed as “u-blox GNSS Standard Driver for Windows”. U-blox has published a flowchart on their website to help users decide which driver to use and how to rollback to older drivers. Here is a copy of the document but it may be too small to read here and may be out of date by the time you read this so I suggest you click on this link to take you to the original document.
U-blox U Center Download
To revert to the generic Windows driver with Windows 10, follow the instructions in the blue circle above. To revert to the older u-blox driver with Windows 10, you will want to first download that driver from the u-blox Product Resource page, then follow the instructions inside the blue circle.